I'm looking for some info on how to replace the starter on my 95 camry xle v6. Any details will be helpful and if possible pictures will make things clearer to me. Thank you in advance for your help.

Removal and Installation:
1) Disconnect the cable from the negative terminal of the battery.
2) On your model, I believe there is a cruise control, remove the battery.
3) Remove the cruise control, remove the actuator cover and disconnect the wiring harnness. Remove the three bolts and then lift out the cruse control actuator. Remove the bracket from beneath the actuator and put aside.
4) Peel the rubber boot away and remove the nut and disconnect the negative battery cable from the magnetic switch terminal on the starter. Disconnect the electrial connector also located on the magnetic switch.
5) Support the starter by hand and remove the two mounting bolts.
6) Remove the starter from the transaxcle.
7) Installation is the reversal of removal. Secure the two mouting bolts and tighten them to 29-31 ft. lbs.
8) The remainder of installation is the reversal of removal. Tighten each component to specifications. Using the ignition switch, "bump" the starter over a few times and check for proper operation.