Help | Advanced Search | Contact Us | Link to Us | Members | Calendar
Welcome Guest ( Log In | Register )

                                        
 
 Reply to this topicStart new topic
> Spacer for carbs DCOE
111
post Apr 8 2005, 08:28 PM
Post #1


Newbie


Group: Guests
Posts: 0
Joined: 15-June 08
Member No.: 12,106
Drives: Toyota
Location: USA
Hi all, I'm trying to locate what appears to just be a spacer that sits between the solex carbs and the intake manifold. I figure any spacer designed for DCOE style carbs will fit just not sure where I could source one. I'll need it to stop the carbs fouling the intake manifold and to bolt the carbs on as only the end part of the studs in the intake manifold are threaded. Cheers Glen RA28 (18RG) RA40 (3TGTE) RA40 (18RC)
Go to the top of the page
 
+ Quote Post
111
post Apr 10 2005, 10:56 PM
Post #2


Newbie


Group: Guests
Posts: 0
Joined: 15-June 08
Member No.: 12,106
Drives: Toyota
Location: USA
What is the isolator kit? I'm after a spacer as far as I can tell. Looks about 10mm thick and goes between the intake manifold and the carb mounting surface with a gasket either side. Seems it's only purpose is to move carbs little further from the manifold. Possibly to give room for the balance tube. Cheers Glen RA28 (18RG) RA40 (3TGTE) RA40 (18RC) > Message: 2 >
Go to the top of the page
 
+ Quote Post
 
  Advanced Search

Start new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

Collapse

> Similar Topics

Topic Title Replies Topic Starter Views Last Action
No entries to display


(c) 2005 Toyotafans.Net. All Rigths Reserved
ToyotaFans.Net is unofficial Toyota forum and not affiliated with or endorsed by Toyota Motor Sales.